The attached video will go over how to install and remove the top drawer cover panel on your Kangaroo and Joey cabinet.
Metal dowel pin installation: The threaded cam lock in the A3 panel may need to be turned using a phillipshead or small flat head screw driver to position the lock to receive the metal dowel pin. You'll then use a small flathead screw driver to screw the dowels into the edges of the A3 panel.
Cam lock open to receive metal dowel pin:
If after assembly your top drawer cover panel does not sit down flat, you may need to move the magnet back slightly. You'll loosen, but not remove, the 2 screws holding the magnet. Once loosened you can push the magnet back and tighten the screws back down.
Magnet too far up:
Magnet pushed back:
